Copper Matrix Crushed Tungsten Carbide Composite Rods with Flux
Brief Introduction
1.tungsten carbide brazing rods they are made of by sintering tungsten carbide scrap and elastic
matrix alloy,Outer layer of the special flux and coloring is marking scrap
grade,the composition of sintering
tungsten carbide scrap is mainly CO and WC,The hardness is HRA
89~91,tire body matal is Ni and copper
alloy,strength can up to 690MPa, hardness HB≥160.
1.Carbide content: 65%,70%
2.Hardness Carbide
(HRA): ≥89.5
3.Matrix alloy melting range: 890-910°C
4.Composite rod size:
Length: 280mm,350mm,450 mm,450mm
Diamter: 12mm,12mm,16mm,22mm
| carbide partical size | inch |
| 1 | 1/8" – 1/16" |
| 2 | 3/16" – 1/8" |
| 3 | 1/4" – 3/16" |
| 4 | 5/16" – 1/4" |
| 5 | 3/8" – 5/16" |
Mass production pic
The oxyacetylene butt, the operating process is as follows:
(1) clean up the workpiece, make the welding workpieces surface
with metallic luster.
(2) the flat position of welding, therefore can use the appropriate
clamping fixture for control of surfacing layer thickness, thick
piece of available.
(3) with a neutral flame preheating, flame core not contact
surface, the distance to 25 mm is advisable.
(4) carbide surfacing welding layer.With YD type electrode surfacing, the use of neutral flame (can be
slightly carbonizing flame) tip is steady on the workpiece surface
movement, the flame of the alloy electrode heating (be careful not
to make flame cone tip contact alloy particles), tire body in the
electrode alloy melt, carbide particles are also falling.Before the tire body of molten metal solidification, the particles
arrange, can use left hand of the alloy electrode fingers, or
another person holding a base electrode or pull rod on graphite rod
in a quick stir particles, making them evenly aligned neatly.Surfacing layer thickness control according to the requirements of
design.
(5) after the workpiece welding, where no ventilation, slow
cooling, cannot quench, conditional usable asbestos blanket cover.
(6) the workpiece after cooling to room temperature, if necessary,
grinding surface surfacing to required size and shape.
(7) clean up the workpiece, remove all splash, slag, etc.
Related products:
Tungsten carbide balls and seats
Tungsten carbide buttons
Tungsten carbide plates and strips
Tungsten carbide rods
Tungsten carbide rollers
Tungsten carbide disc cutters
Tungsten carbide blades
Tungsten carbide special parts
Contact
